More steering column

I finished drilling out the TD5 shaft and I tapered the Series shaft. I got a VERY tight fit. The shaft turned out 1/4 to long. That is fine because I left 1/4 extra on the column. Lucky me.
I will drive in the .188 x.9 inch pin and roset weld over the top. I will also weld around the top. The series shaft is ~1.75 inside of the TD5 shaft. Parton the lame photos. I will put better pictures up later.

IMG_1727.JPG

IMG_1728.JPG

IMG_1730.JPG

IMG_1732.JPG

This entry was posted in power steering. Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *