Getting serious about the breaks

As you know I am using Timm Coopers disk break conversion. I did not buy the kit but instead bought a complete set of castings. Tis has resulted in lots of fiddling around trying to figure out what fasteners to use. Lucky for me the School Bus is located 2 blocks from Lamorna Garage and 1 mile form Tacoma Screw.

It took me several hours but finally I have 1 of 4 done for good. I should not need to do any more work to this hub. I hope the rest go faster.

 

This entry was posted in brakes and hydro boost, School Bus Project. Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *