Brake work

Finally I am back under the school bus! Today I started hard piping the break plumbing. I have bought all the flex lines I need and most if the fittings. I found it was much easer than I had expected. I will put up a bill of materials of the brakes page if you want to do this project in your vehicle. I borrowed a flaring tool from Gord’n at Lamorna Garage. If you do not have access to or the desire to buy a flaring tool you can bend the lines by hand And take them to a brake fitting supplier and let them do all your flairs.

IMG_1596.JPG

IMG_1595.JPG

IMG_1594.JPG

This entry was posted in brakes and hydro boost, School Bus Project. Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *